Horizontal Mounting Bracket for S377E2 cutter

This mount is designed to hold the tool named in the title. All mounts are thermoplastic welded for strength and durability. There are minor variances in tools, so please verify your tool matches the tool shown. If you are unsure, please call us. Click the "Installation and Use" tab for instructions on proper installation and proper usage of the mount.

Horizontal mounts should be installed on a clean flat surface. You may use any type of flat head harware with washers to secure the mount, however we recommend stainless steel. You may drill holes in the baseplate where needed, as long as you are at least 3/4" away from the edge of the baseplate or any welds. We recommend a bolt near each corner of the baseplate (4 in total). Horizontal mounts are designed to be mounted on a stationary surface or in a horizontal slide out tray. Mounts installed in a tilt down tray or at an angle, may not be covered by warranty if damage occurs. All tools must be lifted and replaced in a veritical position, clearing the saddles, before turning or twisting the tools. Opening the tool in the mount or twistin/turning the tool before clearing the sadle, may cause damage not covered by warranty.

Vertical mounts should be installed in a similar fashion. The lower mount should be secured to a clean level surface first. The tips/blades of the tool should then be set into the lower mount supporting the weight of the tool, in order to get a proper location of the upper mount. The upper mount shoud be installed so that is holds the tool in place. The upper mount is NOT designed to hold the weight of the tool. Damage caused by improper instllation may not be covered under warranty.